Electrode is a part of the set designed to actively neutralize excessive electrostatic charges that are created on processed materials.
      It is designed to cooperate with high voltage power supply TZWN-05. When high voltage is applied, strong electric field is created near the points of electrode. It causes intensive ionization of air molecules (disintegration to positive and negative ions). The electrified material near the electrode attracts appropriate ions (of opposite electric polarity) under the influence of electrostatic forces, which neutralizes its charge.

                 

Electrodes are manufactured on an individual order.
Available usable length range of electrodes is 100mm - 1900mm.

How to order:
           Pointed electrode JO96/2/L
                                                         JO96 - model
                                                         /2     - two connection terminals
                                                         /L      - electrode's usable length [mm]

Note!
The electrode's length together with the connection is about 50 mm longer than the usable length of electrode.

      Electrodes JO96/2/L of a total usable length of not more than 2600mm ( with high voltage cable not longer than 1,5m) can be connected to one TZWN-05 power unit.
      Electrodes JO96/2/L are equipped with high voltage connection terminals on both ends and enable cascading of the electrodes, "one after the other". That means that two sequences of JO96/2/L electrodes can be directly connected to the TZWN-05 power supply, with electrodes JO96/1/L at the end of chains. Electrodes with one terminal are then applied in the final place in a sequence.

    

Montage
      In neutralization of discontinuous materials (fabric, yarn, fibers...) one electrode can be used. For continuous (foil, coated paper) the use of two electrodes, one on each side of the film (sheet) is recommended. In this case planes of symmetry of electrodes should be displaced for at least 50 mm. To ensure maximum efficiency of operation, there should not be any metal elements at a distance of 50mm from the electrode.

  

Montage
      Electrode should be mounted at a distance of 3-20mm from the moving material (usually around 5mm). Electrode of the neutralizer should be placed directly in front of the place, where the electrostatic charge is to be removed.

Note!
Many factors (friction, pressure, temperature...) can cause electrostatic charge to be generated once again and accumulate on the material!

Rated data

• type ...................................................................... JO96/2/L
• compatible item ....................................................... power unit TZWN-05
• supply voltage .......................................................... 7kVac, 1,2kHz
• length of a single electrode .......................................... 100 - 1900 mm
• maximum total usable length of electrodes ....................... 2600 mm
• recommended total usable length of electrodes .................. < 2000 mm
• installation distance ................................................... 3 - 20 mm
• operation mode ......................................................... continuous
• maximum number of electrodes for one power supply ........... unlimited
• dimensions: length x width x height ................................. 23 x 23 x (L+85) mm
• weight ..................................................................... 0,65 kg/m

      Correctness of the electrode's operation can be checked by bringing a neon lamp placed on a insulating bar near to the electrode's points. The electric field around the needles should make the lamp glow. In a dark area blue fireflies of corona discharges should be visible on the tips of the needles.